Lexus NX: Name Plate
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Sport Package - - *1 BACK DOOR NAME PLATE *2 BACK DOOR NO. 2 NAME PLATE *3 REAR BODY NO. 4 NAME PLATE *4 SYMBOL EMBLEM ● Non-reusab
Removal
REMOVAL PROCEDURE 1. REMOVE SYMBOL EMBLEM HINT: When removing the symbol emblem, heat the back door outside garnish sub-assembly and symbol emblem using a heat light. Standard: Item Temperature
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU NOTICE:
Turning the power switch on (IG) with connectors disconnected may cause DTCs to be stored. Make sure to clear the DTCs after inspection has been performed.
Do not apply excessive force to the millimeter wave radar sensor assembly connector.
CHECK MILLIMETER WAVE RAD
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. INSTALL CLEARANCE LIGHT ASSEMBLY LH (a) Attach the 2 claws to install the clearance light assembly LH. (b) Install the 3 screws and clip.
© 2016-2026 Copyright www.lexunx.com
