Lexus NX: Radiator Grille (except Sport Package)

Lexus NX Service Manual / Vehicle Exterior / Exterior Panels / Trim / Radiator Grille (except Sport Package)

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 CLEARANCE LIGHT ASSEMBLY LH *2 CLEARANCE LIGHT ASSEMBLY RH *3 HOOD TO FRONT END PANEL SEAL *4 NO. 3 ENGINE ROOM WIRE *5 RADIATOR GRILLE SUB-ASSEMBL

 Removal

REMOVAL PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY Click here 2. REMOVE NO. 3 ENGINE ROOM WIRE Click here 3. REMOVE CLEARANCE LIGHT ASSEMBLY LH (a) for LED Type Side Turn Signal Light: Click here

 Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY Click here 2. REMOVE FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System) Click here 3. REMOVE FRONT CENTER U

SEE MORE:

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FRONT POWER SEAT SWITCH LH (a) Install the front power seat switch LH with the 3 screws. 2. INSTALL FRONT SEAT CUSHION SHIELD LH Clic

 Operation Check

OPERATION CHECK HINT: The blind spot monitor beam axis confirmation is performed to confirm whether the sensor's beam axis is correct, and perform adjustment of the beam axis by using reflector. BLIND SPOT MONITOR BEAM AXIS CONFIRMATION (a) When performing the blind spot monitor beam axis confirmati

© 2016-2025 Copyright www.lexunx.com