Lexus NX: Oil Pump
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 CRANKSHAFT POSITION SENSOR *2 CYLINDER HEAD COVER SUB-ASSEMBLY *3 ENGINE MOUNTING BRACKET RH *4 IGNITION COIL ASSEMBLY *5 CYLINDER HEAD COVER GASKE
Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: Do not remove the oil pump and oil pump relief valve from the timing chain cover assembly. PROCEDURE 1. REMOVE ENGINE AND TRANSAXLE Click here 2. REMOVE ENG
Installation
INSTALLATION PROCEDURE 1. INSTALL TIMING CHAIN COVER ASSEMBLY (a) Apply a light coat of engine oil to the 3 new gaskets. (b) Install the 3 gaskets to the stiffening crankcase assembly. (c) Align th
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RAIN SENSOR (a) Remove the rain sensor cover. Click here (b) Disconnect the rain sensor connector. *a Front view of wire harness connector (to Rain Sensor) (c) Measure the voltage according to the value(s) in the table below. St
Terminals Of Ecu
TERMINALS OF ECU *a Component with harness connected (Power Steering ECU Assembly) - - CHECK POWER STEERING ECU ASSEMBLY (a) Measure the voltage and resistance according to the value(s) in the table below. NOTICE: When the power steering warning light (red) is illuminated due to a malfu
© 2016-2026 Copyright www.lexunx.com
