Lexus NX: On-vehicle Inspection
Lexus NX Service Manual / Suspension / Front Suspension / Front Lower Ball Joint / On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT FRONT LOWER BALL JOINT ASSEMBLY LH
(a) Jack up the vehicle.
(b) Move the front lower suspension arm up and down by hand and check for rattle.
OK:
No rattle.
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE:
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunc
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT LOWER BALL JOINT ASSEMBLY LH (a) Inspect the turning torque of the ball joint. (1) Secure the front lower ball joint in a vise using aluminum plates. (2) Insta
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE:
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no ma
SEE MORE:
Open Circuit in Stop Light Switch Circuit (C1249)
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) receives the stop light switch assembly signal and detects the brake pedal operation status. The skid control ECU (brake booster with master cylinder assembly) has an open detection circuit, which stores this DTC if it de
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE CYLINDER BOOT (a) Using a screwdriver with its wrapped with protective tape, remove the piston seal from the disc brake cylinder assemb
© 2016-2026 Copyright www.lexunx.com
