Lexus NX: On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to follow the correct removal and installation procedures of the airbag ECU assembly.
PROCEDURE
1. INSPECT AIRBAG ECU ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here .gif)
2. INSPECT AIRBAG ECU ASSEMBLY (Vehicle Involved in Collision and Airbag not Deployed)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the airbag ECU assembly installed on the vehicle.
(1) The defects are as follows:
- Cracks on the sensor housing
- Dents on the sensor housing
- Chips on the sensor housing
- Cracks or other damage to the connector
- Peeling of the label
OK:
No defects are found.
HINT:
If any of the defects is found, replace the airbag ECU assembly with a new one.
3. INSPECT AIRBAG ECU ASSEMBLY (Vehicle Involved in Collision and Airbag is Deployed)
(a) Replace the airbag ECU assembly.
HINT:
The airbag ECU assembly should be replaced after any of the airbags has deployed, as it has been subjected to an impact.
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTION CAUTION: Be sure to read Precau
Installation
INSTALLATION PROCEDURE 1. INSTALL AIRBAG ECU ASSEMBLY (a) Check that the power switch is off. (b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal. CAUTION: Wait a
SEE MORE:
HD Radio Tuner Malfunction (B1551,B15A0,B15B3,B15B5,B15B7,B15BA,B15F9)
DESCRIPTION These DTCs are stored when a malfunction occurs in the radio receiver assembly DTC No. Detection Item DTC Detection Condition Trouble Area B1551 HD Radio Tuner Malfunction When one of the conditions below is met:
"HD Radio" tuner decoder malfunction
"HD Radio" tuner
Blind Spot Monitor Sensor
RemovalREMOVAL CAUTION / NOTICE / HINT NOTICE:
Avoid any impact to the blind spot monitor sensor.
Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.
PROCEDURE 1. REMOVE REAR BUMPER COVER Click here 2. REMOVE BLIND SPOT MONITOR SENSOR LH (a) Remove the
