Lexus NX: Operation Check
OPERATION CHECK
CHECK SEAT HEATER (for Front)
(a) Turn the power switch on (IG).
(b) Check that the indicator illuminates and the surface of the front seat warms up, when the seat heater switch on the air conditioning control assembly is turned on.
(c) Check that the front seat surface temperature changes according to the operation of the seat heater switch on the air conditioning control assembly as follows: HI → MID → LO.
CHECK SEAT HEATER (for Rear) (w/ Rear Seat Heater)
(a) Turn the power switch on (IG).
(b) Check that the indicator illuminates and the surface of the rear seat warms up, when the refreshing seat switch turned on.
(c) Check that the rear seat surface temperature changes according to the operation of the seat heater switch on the air conditioning control assembly as follows: HI → MID → LO.
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
If the auxiliary battery voltage is low, the seat heater system may not operate. When "High Power Consumption / Partial Limit On AC/Heater Operation" is displayed on
Terminals Of Ecu
TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (a) Disconnect the I50 air conditioning amplifier assembly connector. (b) Measure the voltage and resistance according to the value(s) in th
Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION (a) Seat heater system data and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctio
SEE MORE:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Meter / Gauge System DTC No. Detection Item Link B1321 Lost Communication with EMV B1326 Lost Communication with Clock Device (Local-CAN) B1500 Fuel Sender Open Detected B1507 Open in Turn Signal Circuit B1508 Sho
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedures listed below are for the LH side.
PROCEDURE 1. INSTALL FRONT DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY LH HINT: When installing the front door lower outside moulding sub-assembly LH, heat
