Lexus NX: Poor Sound Quality in All Modes (Low Volume)
PROCEDURE
(a) Set treble, middle and bass to the initial values and check that the sound is normal.
OK:
The sound returns to normal.
HINT:
Sound quality adjustment measures vary according to the type of amplifier.
| OK | | END |
|
NG | | |
| 2. | COMPARE WITH ANOTHER VEHICLE OF SAME MODEL |
(a) Compare with another vehicle of the same model which is not malfunctioning to see if there is any difference in the sound quality.
OK:
No difference is found.
| OK | | END |
READ NEXT:
PROCEDURE 1. CHECK CONDITION (a) Check with the customer if the vehicle has been turned by a turntable. OK: Vehicle has not been turned by a turntable. HINT: If the vehicle is turned on a
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following
WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly or navigation ECU, always replace it with a new one. If a radio receiver assembly or navigation ECU which was
SEE MORE:
RemovalREMOVAL PROCEDURE 1. REMOVE WHEEL ASSEMBLY (a) Loosen the axle hub nuts approximately 90°. (b) Lift up the vehicle and remove the axle hub nuts and wheel assembly. InstallationINSTALLATION PROCEDURE 1. INSTALL WHEEL ASSEMBLY NOTICE:
Only use axle hub nuts that are compatible with the wh
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click here PROCEDURE 1. CLEAN QUARTER WINDOW ASSEMBLY LH (a) Clean the o
© 2016-2026 Copyright www.lexunx.com
