Lexus NX: Precaution
PRECAUTION
NOTICE:
When disassembling the headlight assembly, use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).
STATIC ELECTRICITY COUNTERMEASURES SST
SST:Desktop antistatic mat set (09890-47010)
-
Wristband
SST:
09891-04020
-
Wristband connection wire (No. 1 grounding wire)
SST:
09891-04030
-
Antistatic mat
SST:
09891-04010
-
Ground connection wire (No. 2 grounding wire)
SST:
09891-04040
.png)
PRECAUTIONS DURING REPLACEMENT
(a) Precautions during procedures:
(1) Before performing any procedures, touch an unpainted metal part or ground bolt of the vehicle to eliminate any static electricity.
(2) To prevent damage to electrical equipment, disconnect the battery power supply before installing and removing electrical equipment.
(3) Never touch the electronic parts of a printed wire board or the pins of an integrated circuit.
(4) When performing procedures, do not allow clothing to come near or contact parts.
(b) Wear the SST (wristband) firmly on your wrist.
SST:
09891-04020
(c) Connect the SST (No. 2 grounding wire) and SST (antistatic mat) to an appropriate grounding point in the workspace and on the work table.
SST:
09891-04040
09891-04010
HINT:
When working inside the vehicle:
Connect SST (No. 2 grounding wire) to the unpainted metal part of a grounded bolt, etc.
.png)
(d) Connect SST (No. 1 grounding wire), SST (wristband) and SST (antistatic mat).
SST:
09891-04030
(e) Always place the headlight assembly and its components on SST (antistatic mat).
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 HEADLIGHT ASSEMBLY LH - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *A w/ Headlight ECU - - *1 FRONT SIDE MAKER LIGHT
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY (a) except Spo
Disassembly
DISASSEMBLY PROCEDURE 1. PRECAUTION NOTICE:
Be sure to read Precaution thoroughly before servicing.
Click here
Do not reuse parts which have reduced fastening ability due to thread damage.
Wh
SEE MORE:
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE KICK DOOR CONTROL BRACKET (w/ Hands Free Power Back Door) Click here 2. REMOVE KICK DOOR CONTROL SENSOR (w/ Hands Free Power Back Door) Click here 3. REMOVE NO. 2 LUGGAGE ROOM WIRE (a) w/ Intuitive Parking Assist System: Disconnect the 4 connectors. NOTICE: Do not
Check Bus 2 Lines for Short Circuit
DESCRIPTION There may be a short circuit between the CAN main bus wire and/or CAN branch wire when the resistance between terminals 18 (CA4H) and 17 (CA4L) of the central gateway ECU (network gateway ECU) is below 54 Ω. Symptom Trouble Area
*1: w/ Headup Display
*2: w/ ASC System *3: for T
