Lexus NX: Rear Combination Light Assembly
READ NEXT:
Precaution
PRECAUTION NOTICE: When disassembling the rear combination light assembly, use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the
Components
COMPONENTS ILLUSTRATION *1 TONNEAU COVER ASSEMBLY - - ILLUSTRATION *1 DECK BOARD ASSEMBLY *2 DECK FLOOR BOX LH *3 DECK FLOOR BOX RH *4 NO. 2 DECK BOARD SUB-ASSEMBLY
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. REMOVE REAR BUMPER ASSEMBLY Click here 2.
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL DOOR SIDE AIRBAG SENSOR LH (a) Check that the power switch is off. (b) Check that the cable is disconnected from the negative (-) aux
Installation
INSTALLATION PROCEDURE 1. INSTALL AUTOMATIC LIGHT CONTROL SENSOR (a) Attach the 2 claws to install the automatic light control sensor. 2. INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY Click here 3. INSPECT AUTOMATIC LIGHT CONTROL SYSTEM for Single Beam Headlight: Click here for Triple Beam He
© 2016-2026 Copyright www.lexunx.com
