Lexus NX: Precaution

PRECAUTION

PRECAUTION FOR VEHICLE WITH AIRBAG

(a) Some operations in this section may affect the airbag. Prior to performing the corresponding operations, read the SRS Precaution.

Click here

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified

 Removal

REMOVAL PROCEDURE 1. TABLE OF BOLT, SCREW AND CLIP HINT: All bolts, screws, and clips relevant to installing and removing the instrument panel are shown along with their alphabet code in the table bel

 Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (a) Remove the 3 screws <A> or <B> and No. 1 heater to register duct sub-assembly. *a Screw <

SEE MORE:

 Kick Sensor Circuit (B2205)

DESCRIPTION B2205 is output when the multiplex network door ECU detects that the kick door control sensor is stuck on. DTC No. Detection Item DTC Detection Condition Trouble Area B2205 Kick Sensor Circuit One of the following conditions is met for approximately 60 seconds or more:

 Warning Notification Function Malfunction

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur: A communication malfunction DTC may be stored. The radio receiver assembly may not

© 2016-2026 Copyright www.lexunx.com