Lexus NX: Rear Brake
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
NOTICE:
When the brake pedal is first depressed after repla
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE CYLINDER BOOT (a) Using a screwdriv
SEE MORE:
Low Output Signal of Front Speed Sensor RH (C1271,C1272,C1464,C1465)
DESCRIPTION Each speed sensor detects the wheel speed and sends the signals to the skid control ECU (brake booster with master cylinder assembly). These signals are used for ABS control. DTCs C1271 and C1272 are cleared when the speed sensor sends a wheel speed signal or when Test Mode ends. DTCs C1
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT SEAT ASSEMBLY LH Click here 2. REMOVE FRONT SEAT ASSEMBLY RH HINT: Use the same procedure as for the driver seat. 3. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (a) Disconnect the 2 connectors. (b) Detach the 6 clamps. (c) Detach the clamp.
© 2016-2026 Copyright www.lexunx.com
