Lexus NX: Reassembly

Lexus NX Service Manual / Vehicle Exterior / Door / Hatch / Hood / Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL ENGINE HOOD LOCK STRIKER ASSEMBLY

(a) Attach the guide.

(b) Install the engine hood lock striker assembly with the 2 bolts.

Torque:

8.0 N·m {82 kgf·cm, 71 in·lbf}

2. INSTALL RADIATOR SUPPORT OPENING COVER

Click here

3. INSTALL HOOD AUXILIARY CATCH HOOK ASSEMBLY

(a) Attach the guide.

(b) Install the hood auxiliary catch hook assembly with the 2 bolts.

Torque:

8.0 N·m {82 kgf·cm, 71 in·lbf}

4. CONNECT WASHER HOSE ASSEMBLY

(a) Attach the 4 clamps to connect the washer hose assembly.

5. INSTALL WASHER NOZZLE SUB-ASSEMBLY

Click here

6. INSPECT WASHER NOZZLE SUB-ASSEMBLY

Click here

7. ADJUST WASHER NOZZLE SUB-ASSEMBLY

Click here

8. INSTALL HOOD TO FRONT FENDER SEAL LH

(a) Attach the 2 claws to install the hood to front fender seal LH.

9. INSTALL HOOD TO FRONT FENDER SEAL RH

HINT:

Use the same procedure as for the LH side.

10. INSTALL HOOD INSULATOR

(a) Attach the 2 guides.

(b) Install the hood insulator with the 7 clips.

SEE MORE:

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored. w

Lost Communication with Drive Motor Control Module "A" (U0110-159,U0110-656,U0110-657)

DESCRIPTION For a description of the inverter. Click here The MG ECU, which is built into in the inverter with converter assembly, controls motor (MG2) based on commands from the hybrid vehicle control ECU. The MG ECU monitors communication data and detects malfunctions. The hybrid vehicle control

Lexus NX: Reassembly

READ NEXT:

Hood Lock Control Cable Assembly

Components

Removal

SEE MORE:

Problem Symptoms Table

Lost Communication with Drive Motor Control Module "A" (U0110-159,U0110-656,U0110-657)