Lexus NX: Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NUT
| (a) Install the 2 nuts. |
|
.png)
2. INSTALL RADIATOR GRILLE EMBLEM
| (a) Attach the claw and guide to install the radiator grille emblem. |
|
.png)
(b) Install the 2 screws.
3. INSTALL RADIATOR GRILLE
4. INSTALL RADIATOR GRILLE MOULDING
(a) Attach the 12 claws to install the radiator grille moulding.
.png)
5. INSTALL FRONT BUMPER HOLE COVER LH
| (a) Attach the 4 claws and guide to install the front bumper hole cover LH. |
|
.png)
6. INSTALL FRONT BUMPER HOLE COVER RH
HINT:
Use the same procedure described for the LH side.
7. INSTALL FRONT BUMPER EXTENSION MOUNTING BRACKET
| (a) Install the front bumper extension mounting bracket with the 2 screws. |
|
.png)
8. INSTALL FRONT CENTER ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)
Click here .gif)
9. INSTALL FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
Click here
10. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
Click here
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL RADIATOR GRILLE SUB-ASSEMBLY (a) Attach the 15 claws and 2 guides to install the radiator grille sub-assembly. (b) Install the 2 outside moulding retainers. (c) Insta
Components
COMPONENTS ILLUSTRATION *1 CLEARANCE LIGHT ASSEMBLY LH *2 CLEARANCE LIGHT ASSEMBLY RH *3 FRONT BUMPER GUARD ASSEMBLY *4 HOOD TO FRONT END PANEL SEAL *5 NO. 3 ENGINE ROOM WIRE
SEE MORE:
Different Diameter Tire Malfunction (C1348)
DESCRIPTION If the hybrid vehicle control ECU receives a signal from the skid control ECU (brake booster with master cylinder assembly) that the AWD system is malfunctioning, the hybrid vehicle control ECU outputs this DTC. DTC No. Detection Item INF Code DTC Detection Condition Trouble A
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE:
When replacing with a new inverter with converter assembly, securely lock the retainer of the inverter cooling hose since it is not locked.
Before replacing the wire harness boot, check if any DTCs are output.
HINT: Remove the tape that was attach
