Lexus NX: Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NUT
| (a) Install the 2 nuts. |
|
.png)
2. INSTALL RADIATOR GRILLE EMBLEM
| (a) Attach the claw and guide to install the radiator grille emblem. |
|
.png)
(b) Install the 2 screws.
3. INSTALL NO. 3 RADIATOR GRILLE GARNISH
| (a) Attach the 4 claws to install the No. 3 radiator grille garnish. |
|
.png)
4. INSTALL RADIATOR GRILLE
5. INSTALL RADIATOR GRILLE MOULDING
(a) Attach the 22 claws to install the radiator grille moulding.
.png)
6. INSTALL FRONT BUMPER HOLE COVER LH
| (a) Attach the 2 claws and guide to install the front bumper hole cover LH. |
|
.png)
7. INSTALL FRONT BUMPER HOLE COVER RH
HINT:
Use the same procedure described for the LH side.
8. INSTALL LOWER NO. 1 RADIATOR GRILLE
| (a) Attach the 9 claws to install the lower No. 1 radiator grille. |
|
.png)
9. INSTALL FRONT BUMPER EXTENSION MOUNTING BRACKET
| (a) Install the front bumper extension mounting bracket with the 2 screws. |
|
.png)
10. INSTALL FRONT CENTER ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)
Click here .gif)
11. INSTALL FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
Click here
12. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
Click here
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL RADIATOR GRILLE SUB-ASSEMBLY (a) Attach the 14 claws and the 4 guides to install the radiator grille sub-assembly. (b) Install the 2 outside moulding retainers. (c) I
Components
COMPONENTS ILLUSTRATION *1 REAR BUMPER COVER *2 REAR BUMPER NO. 1 PLATE *3 REAR FLOOR SIDE MEMBER COVER - - ILLUSTRATION *1 REAR BUMPER NO. 1 REINFORCEMENT *2 REAR BUM
SEE MORE:
Idle Control System (P0505)
DESCRIPTION The idle speed is controlled by the electronic throttle control system. The electronic throttle control system is comprised of: 1) one valve type throttle body with motor assembly; 2) the throttle actuator, which operates the throttle valve; 3) the throttle position sensor, which detects
Terminals Of Ecu
TERMINALS OF ECU CHECK FRONT POWER SEAT SWITCH LH (a) Disconnect the g11 and g12 front power seat switch LH connectors. (b) Measure the voltage and resistance according to the value(s) in the table below. Tester Connection Wiring Color Terminal Description Condition Specified Condition
