Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL RADIATOR GRILLE SUB-ASSEMBLY
(a) Attach the 14 claws and the 4 guides to install the radiator grille sub-assembly.
(b) Install the 2 outside moulding retainers.
(c) Install the 6 screws.
.png) | Screw | .png) | Outside Moulding Retainer |
2. INSTALL FRONT BUMPER GUARD ASSEMBLY
Click here .gif)
3. INSTALL HOOD TO FRONT END PANEL SEAL
Click here
4. INSTALL CLEARANCE LIGHT ASSEMBLY LH
Click here
5. INSTALL CLEARANCE LIGHT ASSEMBLY RH
HINT:
Use the same procedure described for the LH side.
6. INSTALL NO. 3 ENGINE ROOM WIRE
Click here
7. INSTALL FRONT BUMPER ASSEMBLY
Click here
8. ADJUST FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
Click here
HINT:
When only the radiator grille assembly is removed and reinstalled, it is not necessary to adjust the front television camera assembly (Such as when removing or installing the radiator grille in order to remove or install the headlight assembly).
9. PERFORM CALIBRATION (w/ Intelligent Clearance Sonar System)
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR BUMPER COVER *2 REAR BUMPER NO. 1 PLATE *3 REAR FLOOR SIDE MEMBER COVER - - ILLUSTRATION *1 REAR BUMPER NO. 1 REINFORCEMENT *2 REAR BUM
Removal
REMOVAL CAUTION / NOTICE / HINT w/ Blind Spot Monitor System: HINT: If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the
SEE MORE:
Luggage Compartment Room Light
ComponentsCOMPONENTS ILLUSTRATION *1 NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY - - RemovalREMOVAL PROCEDURE 1. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side) (a) Put protective tape around the No. 1 luggage compartment light assembly. Protective Tape (b) Using
Jam Protection Function Activates During Power Back Door Operation
DESCRIPTION When the jam protection function activates during power back door operation, one of the following may be the cause: 1) improper fit of back door, or a foreign object is stuck in the back door, 2) malfunctioning power back door sensor assembly circuit or 3) malfunctioning multiplex networ
