Lexus NX: Rear Bumper
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR BUMPER COVER *2 REAR BUMPER NO. 1 PLATE *3 REAR FLOOR SIDE MEMBER COVER - - ILLUSTRATION *1 REAR BUMPER NO. 1 REINFORCEMENT *2 REAR BUM
Removal
REMOVAL CAUTION / NOTICE / HINT w/ Blind Spot Monitor System: HINT: If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE KICK DOOR CONTROL BRACKET (w/ Hands Free Power Back Door) Click here 2. REMOVE KICK DOOR CONTROL SENSOR (w/ Hands Free Power Back Door) Click here 3. REMOVE NO. 2 L
SEE MORE:
One or more Power Seat Motors do not Operate
DESCRIPTION Signals are input into the front power seat switch LH. The built-in ECU manages the signals received from the front power seat switch LH, and operates each motor. If the front power seat switch LH receives more than 2 motor operation signals, the motor is stopped. Manual operation is res
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE NO. 5 MOULDING TAPE (a) Remove the No. 5 moulding tape (double-sided tape). HINT: Do not pull on the No. 5 moulding tape (double-sided
© 2016-2026 Copyright www.lexunx.com
