Lexus NX: Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL REAR LIGHT SOCKET AND WIRE LH
(a) Attach the wire harness clamp and connect the connector to install the rear light socket and wire LH.
2. INSTALL REAR LIGHT GASKET LH
(a) Install a new rear light gasket LH.
READ NEXT:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. INSTALL REAR LIGHT ASSEMBLY LH (a)
Components
COMPONENTS ILLUSTRATION *1 LOWER OUTER MIRROR COVER LH *2 OUTER MIRROR BEZEL LH *3 OUTER MIRROR COVER LH *4 OUTER MIRROR LH *5 SIDE TURN SIGNAL LIGHT ASSEMBLY LH - -
SEE MORE:
Short in Curtain Shield Airbag (RH) Squib Circuit (B1830-B1833)
DESCRIPTION The curtain shield squib RH circuit consists of the airbag ECU assembly and curtain shield airbag assembly RH. The circuit instructs the SRS to deploy when deployment conditions are met. These DTCs are stored when a malfunction is detected in the curtain shield squib RH circuit. DTC N
Removal
REMOVAL PROCEDURE 1. TABLE OF BOLT, SCREW AND CLIP HINT: All bolts, screws, and clips relevant to installing and removing the instrument panel are shown along with their alphabet code in the table below. 2. DISABLE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column) (a) D
© 2016-2026 Copyright www.lexunx.com
