Lexus NX: Side Turn Signal Light Assembly

Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Side Turn Signal Light Assembly

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 LOWER OUTER MIRROR COVER LH *2 OUTER MIRROR BEZEL LH *3 OUTER MIRROR COVER LH *4 OUTER MIRROR LH *5 SIDE TURN SIGNAL LIGHT ASSEMBLY LH - -

 Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE OUTER MIRROR LH Click here 2. REM

 Inspection

INSPECTION PROCEDURE 1. INSPECT SIDE TURN SIGNAL LIGHT ASSEMBLY LH (a) Apply auxiliary battery voltage to the connector and check the light illumination condition. OK: Condition Specified Con

SEE MORE:

 Terminals Of Ecu

TERMINALS OF ECU NOTICE: Turning the power switch on (IG) with connectors disconnected may cause DTCs to be stored. Make sure to clear the DTCs after inspection has been performed. Do not apply excessive force to the millimeter wave radar sensor assembly connector. CHECK MILLIMETER WAVE RAD

 Curtain Shield Airbag Sensor (RH) (B1630,B1632,B1635,B1637)

DESCRIPTION The side airbag sensor assembly LH or RH consists of a lateral deceleration sensor, etc. If the airbag ECU assembly receives signals from the lateral deceleration sensor, it determines whether the SRS should be activated. DTC B1630, B1632, B1635 or B1637 is stored when a malfunction is d

© 2016-2025 Copyright www.lexunx.com