Lexus NX: Removal
REMOVAL
PROCEDURE
1. PRECAUTION
Click here .gif)
2. CHECK FOR DTC
(a) Check for DTCs.
Click here
NOTICE:
Confirm that P0AA6 (Hybrid Battery Voltage System Isolation Fault) is not output before removing or installing an HV battery module. If this DTC is output, perform troubleshooting for this DTC first.
Click here
3. REMOVE SERVICE PLUG GRIP
Click here
4. DISCONNECT WIRE HARNESS
Click here
5. DISCONNECT INVERTER RESERVE TANK ASSEMBLY
Click here
6. REMOVE CONNECTOR COVER ASSEMBLY
Click here
7. CHECK TERMINAL VOLTAGE
Click here
8. INSTALL CONNECTOR COVER ASSEMBLY
Click here
9. REMOVE REAR SEAT ASSEMBLY
for Manual Seat: Click here
for Power Seat: Click here
10. REMOVE NO. 2 HYBRID VEHICLE BATTERY SHIELD REINFORCEMENT
Click here
11. REMOVE HV BATTERY JUNCTION BLOCK ASSEMBLY
CAUTION:
Wear insulated gloves and use insulated tools.
| (a) Using an insulated tool, remove the 3 nuts, and disconnect the 2 No. 2 frame wires (high-voltage cables) and ground terminal. |
|
| (b) Disconnect the 4 connectors. NOTICE: Insulate the removed connector with insulating tape. |
|
| (c) Remove the 3 nuts and hybrid junction block assembly. NOTICE: If the hybrid battery junction block assembly has been dropped, replace it with a new one. |
|
READ NEXT:
Inspection
INSPECTION PROCEDURE 1. INSPECT HV BATTERY JUNCTION BLOCK ASSEMBLY (a) Inspect SMRB: (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connect
Installation
INSTALLATION PROCEDURE 1. INSTALL HV BATTERY JUNCTION BLOCK ASSEMBLY CAUTION: Wear insulated gloves and use insulated tools. (a) Install the hybrid battery junction block assembly with the 3 nuts. Tor
SEE MORE:
G Sensor Failure (C1647)
DESCRIPTION The clearance warning sonar ECU assembly communicates with the airbag ECU assembly (yaw rate and acceleration sensor) via CAN communication, and if it is determined that the airbag ECU assembly (yaw rate and acceleration sensor) is malfunctioning, DTC C1647 is stored. DTC No. Detect
Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio receiver assembly via this circuit. The sound signal that has been sent is amplified by the stereo component amplifier assembly and then is sent to the speakers. If there is an open or shor
