Lexus NX: Removal
REMOVAL
PROCEDURE
1. REMOVE AIR CONDITIONING UNIT ASSEMBLY
Click here .gif)
2. REMOVE BLOWER ASSEMBLY
| (a) Disconnect the No. 1 blower damper servo sub-assembly connector. |
|
.png)
(b) Detach the 3 clamps and remove the air conditioning harness assembly.
| (c) Remove the 2 screws. |
|
.png)
(d) Detach the 2 claws and remove the blower assembly.
READ NEXT:
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE AIR FILTER CASE (a) Detach the claw and guide and remove the air filter case. 2. REMOVE AIR REFINER ELEMENT (a) Remove the air refiner element.
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY (a) Install the link of the No. 1 blower damper servo sub-assembly to the link of the blower assembly as shown in the illustra
Installation
INSTALLATION PROCEDURE 1. INSTALL BLOWER ASSEMBLY (a) Attach the 2 claws to install the blower assembly. (b) Install the 2 screws. (c) Attach the 3 clamps to install the air conditioning harness assem
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *A for Front Passenger Side *B for Driver Side *1 FRO
Dtc Check / Clear
DTC CHECK / CLEAR DTC CHECK (a) Turn the power switch off. (b) Connect the Techstream to the DLC3. (c) Turn the power switch on (IG). (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Occupant Detection / Trouble Codes. (f) Check for DTCs by following the prompts on the Te
© 2016-2026 Copyright www.lexunx.com
