Lexus NX: Blower Unit
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 BLOWER ASSEMBLY - - ILLUSTRATION *1 AIR FILTER CASE *2 AIR REFINER ELEMENT *3 BLOWER WITH FAN MOTOR SUB-ASSEMBLY *4 NO. 1 BLOWER DAMPER SERV
Removal
REMOVAL PROCEDURE 1. REMOVE AIR CONDITIONING UNIT ASSEMBLY Click here 2. REMOVE BLOWER ASSEMBLY (a) Disconnect the No. 1 blower damper servo sub-assembly connector. (b) Detach the 3
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE AIR FILTER CASE (a) Detach the claw and guide and remove the air filter case. 2. REMOVE AIR REFINER ELEMENT (a) Remove the air refiner element.
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REPAIR INSTRUCTION Click here 2. INSTALL NO. 3 BLACK OUT TAPE LH HINT: When installing the No. 3 black out tape LH, heat the front door pan
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY Click here 2. REMOVE NO. 3 ENGINE ROOM WIRE Click here 3. REMOVE CLEARANCE LIGHT ASSEMBLY LH Click here 4. REMOVE CLEARANCE LIGHT ASSEMBLY RH HINT: Use the same procedure described for the LH side. 5. REMOVE HOOD TO FRONT END PANEL SEAL Click h
© 2016-2026 Copyright www.lexunx.com
