Lexus NX: Roof Drip Side Finish Moulding
Lexus NX Service Manual / Vehicle Exterior / Exterior Panels / Trim / Roof Drip Side Finish Moulding
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/ Roof Rack - - *1 REAR ROOF DRIP SIDE FINISH MOULDING LH *2 ROOF DRIP SIDE FINISH MOULDING CLIP *3 ROOF DRIP SIDE FINISH MOULDING LH - -
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE ROOF RACK ASSEMBLY (w/ Roof Rack) Click
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL ROOF DRIP SIDE FINISH MOULDING CL
SEE MORE:
Dtc Check / Clear
DTC CHECK / CLEAR DTC CHECK USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes. (e) Check for DTCs. Click here Body Electrical > Air Conditioner &
ABS Warning Light does not Come ON
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) is connected to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (brake booster with master cylinder assembly), perform initialization and calibrati
© 2016-2026 Copyright www.lexunx.com
