Lexus NX: Steering Column Assembly (for Power Tilt And Power Telescopic Steering Column)
Lexus NX Service Manual / Steering / Steering Column / Steering Column Assembly (for Power Tilt And Power Telescopic Steering Column)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 COLUMN HOLE COVER SILENCER SHEET *2 COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY *3 ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY *4 NO. 1 AI
Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE:
Do not replace the spiral with sensor cable sub-assembly with the battery connected and the power switch on (IG).
Do not rotate the spiral with sensor cabl
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE:
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
PROCEDURE 1. REMOVE STEERING LOCK ACTU
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH *2 REAR BUMPER SIDE SEAL LH *3 REAR TIRE PRESSURE MONITOR INITIATOR *4 REAR WHEEL HOUSE FRONT PLATE LH *5 REAR WHEEL HOUSE LINER LH - - N*m (kgf*cm, ft.*lbf): Specified torque - -
Installation
INSTALLATION PROCEDURE 1. INSTALL STOP LIGHT SWITCH ASSEMBLY (a) Turn the stop light switch assembly in the clockwise direction until it reaches the standard shaft protrusion amount and temporarily install it. Standard: 0.5 to 1.7 mm (0.0197 to 0.0669 in.) NOTICE: Do not depress the brake pedal.
© 2016-2025 Copyright www.lexunx.com
