Lexus NX: Tire Pressure Warning Initiator Driver
Lexus NX Service Manual / Suspension / Tire Pressure Monitoring / Tire Pressure Warning Initiator Driver
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the power switch off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal. Click here 2. REMOVE NO. 3 D
Installation
INSTALLATION PROCEDURE 1. INSTALL TIRE PRESSURE MONITOR INITIATOR DRIVER (a) Attach the 2 claws to install the tire pressure monitor initiator driver. 2. INSTALL ECU INTEGRATION BOX RH (a) Install the
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR DOOR OUTSIDE HANDLE ASSEMBLY LH (a) Check that the LED illuminates. (1) Apply 6.0 V (4 dry cell batteries in series) to each terminal and check the illumination state of the light. OK: Measurement Condition Specified Condition Battery positive (+) â†
Mass Air Flow Circuit Range / Performance Problem (P0101)
DESCRIPTION Refer to DTC P0102. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory P0101 Mass Air Flow Circuit Range / Performance Problem All of the following conditions continue for more than 10 seconds (2 trip detection logic): (a) The engine
© 2016-2026 Copyright www.lexunx.com
