Lexus NX: Tire Pressure Warning Receiver
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the power switch off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal. Click here 2. REMOVE DECK BO
Installation
INSTALLATION PROCEDURE 1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER (a) Connect the connector to the tire pressure warning ECU and receiver. (b) Attach the 2 guides to temporarily install the tir
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT SHIFT LOCK CONTROL ECU (a) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connection Condition Specified Condition 5 (IG) - Body ground Power switch on (IG) 11 to 14 V Power switch off Below 1 V
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
After replacing the radio receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary (w/ SXM System).
If the DCM (telematics transceiver) has been replaced, perform the DCM Activation procedure usi
© 2016-2026 Copyright www.lexunx.com
