Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | AIR CLEANER CAP SUB-ASSEMBLY | *2 | AIR CLEANER CASE SUB-ASSEMBLY |
| *3 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY | *4 | ENGINE WIRE |
| *5 | FAN AND GENERATOR V BELT | *6 | GROUND WIRE |
| *7 | NO. 1 ENGINE COVER SUB-ASSEMBLY | *8 | RADIATOR RESERVE TANK ASSEMBLY |
| *9 | REAR ENGINE UNDER COVER RH | - | - |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | CAMSHAFT | *2 | CAMSHAFT TIMING GEAR ASSEMBLY |
| *3 | CAMSHAFT TIMING SPROCKET | *4 | CYLINDER HEAD COVER SUB-ASSEMBLY |
| *5 | IGNITION COIL ASSEMBLY | *6 | NO. 1 CAMSHAFT BEARING |
| *7 | NO. 1 CHAIN TENSIONER ASSEMBLY | *8 | NO. 2 CAMSHAFT |
| *9 | NO. 2 CAMSHAFT BEARING | *10 | OIL CONTROL VALVE FILTER |
| *11 | TIMING CHAIN COVER PLATE | *12 | TIMING CHAIN COVER TIGHT PLUG |
| *13 | TIMING CHAIN GUIDE | *14 | CYLINDER HEAD COVER GASKET |
| *15 | NO. 1 CAMSHAFT BEARING CAP | *16 | NO. 2 CAMSHAFT BEARING CAP |
| *17 | NO. 3 CAMSHAFT BEARING CAP | *18 | GASKET |
| *19 | SEAL WASHER | - | - |
| | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE SERVICE PLUG GRIP Click here 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Click here 3. REMOVE REAR ENGINE UNDER COVER RH Click here 4. REMOVE FAN AND GENERATOR V B
Precaution
PRECAUTION HINT:
Any digits beyond the 0.01 mm (1/1000 in.) place for standard, minimum and maximum values should be used as a reference only.
When both standard and maximum or minimum values are
SEE MORE:
IG Signal Circuit
DESCRIPTION This circuit detects whether the power switch is on (IG) or off, and sends this information to the main body ECU (multiplex network body ECU). WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedur
Lost Communication with EMV (B1321)
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area Memory B1321 Lost Communication with EMV
DTC Detection Condition: IG+ voltage 9.5 to 11.5 V or higher
Malfunction Status: Lost communication with radio receiver assembly
Malfunction Duration: 30 seconds
