Lexus NX: Camera Position Adjustment Incomplete (C1697)
DESCRIPTION
This DTC is stored when the parking assist ECU judges that the camera initial setting has not been memorized (camera view adjustment is incomplete).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1697 | Camera Position Adjustment Incomplete | Camera initial setting has not been memorized |
|
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" mark is displayed on the parking assist ECU after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click here
.gif)
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE
| 1. | ADJUST SETTINGS (CAMERA VIEW ADJUSTMENT) |
(a) Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.
(1) Refer to camera view adjustment.
Click here
|
.gif)
| 2. | CHECK FOR DTC |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
OK:
DTC C1697 is not output.
HINT:
- If DTC C1697 is output, perform the camera view adjustment again.
- If DTC C1697 is still output after performing the camera view adjustment 3 times, replace the parking assist ECU.
| OK | .gif) | END (CAMERA VIEW ADJUSTMENT IS DEFECTIVE) |
| NG | | REPLACE PARKING ASSIST ECU |
READ NEXT:
Front Camera Internal Circuit (C2A60)
DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the front television camera assembly via CAN communication. DTC No. Detection Item DTC De
Side Camera LH Internal Circuit (C2A61)
DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the side television camera assembly LH via CAN communication. DTC No. Detection Item DTC
Side Camera RH Internal Circuit (C2A62)
DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the side television camera assembly RH via CAN communication. DTC No. Detection Item DTC
SEE MORE:
DC/DC Converter Voltage Sensor "A" Low (P0E33-589,P0E34-590)
DESCRIPTION The MG ECU, which is built into the inverter with converter assembly, detects pre-boosting high voltage (VL) using the voltage sensor in the boost converter to control boosting. The MG ECU also monitors the boost converter voltage sensor signal line and detects malfunctions. DTC No.
Terminals Of Ecu
TERMINALS OF ECU CHECK ABSORBER CONTROL ECU *a Component with harness connected (Absorber Control ECU) - - HINT:
Inspect the connectors from the back side while the connectors are connected.
Check the operation of a particular valve by listening for operating sounds or by using the
