Lexus NX manuals

Lexus NX: Installation

Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Clearance Light Assembly (for Led Type Turn Signal Light) / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure described below is for the LH side.

PROCEDURE

1. INSTALL CLEARANCE LIGHT ASSEMBLY LH

(a) Attach the 2 claws to install the clearance light assembly LH.

(b) Install the 3 screws and clip.

Screw

Clip

(c) Attach the 2 wire harness clamps.

(d) w/ Headlight Cleaner System:

(1) Attach the hose clamp.

(2) Attach the claw to connect the headlight cleaner hose.

2. INSTALL FRONT BUMPER ASSEMBLY

(a) except Sport Package:

Click here

(b) for Sport Package:

Click here

READ NEXT:

 Fog Light Assembly (except Sport Package)

 Components

COMPONENTS ILLUSTRATION *1 FOG LIGHT ASSEMBLY LH *2 FRONT BUMPER ASSEMBLY

 Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY Click here 2

SEE MORE:

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP (w/o Roof Rack, except Glass Roof) NOTICE: It is only necessary to perform this procedure when

 Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT LUMBAR POWER SEAT SWITCH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 3 (H) - 5 (B) Hold switch on Below 1 Ω 1 (R) - 2 (E) 2 (E) -

© 2016-2026 Copyright www.lexunx.com