Lexus NX: Front Door Outside Moulding
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY LH *2 HOLE COVER ILLUSTRATION *1 FRONT DOOR UPPER OUTSIDE MOULDING PAD - - ● Non-reusable part
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedures listed below are for the LH side.
PROCEDURE 1. REMOVE FRONT DOOR LOWER OUTSIDE MOULDING SUB
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE FRONT DOOR UPPER OUTSIDE MOULDING P
SEE MORE:
STSW Monitor Malfunction (B2275)
DESCRIPTION This DTC is stored when a malfunction is detected in the starter circuit inside the certification ECU (smart key ECU assembly). DTC No. Detection Item DTC Detection Condition Trouble Area Note B2275 STSW Monitor Malfunction Certification ECU (smart key ECU assembly) in
Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. INSTALL BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER) HINT:
When installing the seat cover, refer to the precautions in order to prevent wrinkles from
© 2016-2026 Copyright www.lexunx.com
