Lexus NX: Wheel Opening Moulding(for Front)

Lexus NX Service Manual / Vehicle Exterior / Exterior Panels / Trim / Wheel Opening Moulding(for Front)

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 FRONT FENDER MOULDING SUB-ASSEMBLY LH - - ILLUSTRATION *1 NO. 1 MOULDING TAPE *2 NO. 2 MOULDING TAPE ● Non-reusable part - -

 Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH H

 Disassembly

DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE NO. 1 MOULDING TAPE (a) Remove the

SEE MORE:

 Rear Door LH ECU Communication Stop (B2324)

DESCRIPTION This DTC is output when LIN communication between the rear power window regulator motor assembly LH and main body ECU (multiplex network body ECU) stops for 10 seconds or more. DTC No. Detection Item DTC Detection Condition Trouble Area B2324 Rear Door LH ECU Communication

 12-volt battery

Location The 12-volt battery is located in the left-hand side of luggage compartment. ■Before recharging When recharging, the 12-volt battery produces hydrogen gas which is flammable and explosive. Therefore, observe the following precautions before recharging: If recharging with the

© 2016-2026 Copyright www.lexunx.com