Lexus NX: Fog Light Assembly (for Sport Package)
Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Fog Light Assembly (for Sport Package)
READ NEXT:
Precaution
PRECAUTION NOTICE: When disassembling the fog light assembly, use static electricity countermeasures SST (desktop anti-static mat set) and observe all precautions to prevent damage to the system by el
Components
COMPONENTS ILLUSTRATION *1 FOG LIGHT ASSEMBLY LH - - ILLUSTRATION *1 FOG LIGHT GASKET *2 FOG LIGHT LENS LH *3 FOG LIGHT UNIT LH *4 PIVOT COLLAR ● Non-reusable
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY Click here 2
SEE MORE:
Motor Electronics Coolant Temperature Sensor Circuit Low (P0A02-719,P0A03-720)
DESCRIPTION Refer to the description for DTC P0A01-726. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P0A02-719 Motor Electronics Coolant Temperature Sensor Circuit Low Short to ground in the HV coolant temperature sensor circuit (
Replacement
REPLACEMENT PROCEDURE 1. REPLACE INTAKE VALVE GUIDE BUSH (a) Heat the cylinder head sub-assembly to approximately 80 to 100°C (176 to 212°F). (b) Place the cylinder head sub-assembly on wooden blocks. (c) Using SST and a hammer, tap out the intake valve guide bush. SST: 09201-01055 SST: 09950-7
© 2016-2026 Copyright www.lexunx.com
