Lexus NX: Components
Lexus NX Service Manual / Engine & Hybrid System / 2ar-fxe (emission Control) / Canister / Components
COMPONENTS
ILLUSTRATION
| *1 | CANISTER PUMP MODULE | *2 | CHARCOAL CANISTER ASSEMBLY |
| *3 | FRONT FLOOR COVER CENTER LH | *4 | VENT LINE HOSE |
| *5 | AIR INLET LINE HOSE | *6 | PURGE LINE HOSE |
.png) | Specified torque: N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT FLOOR COVER CENTER LH Click here 2. REMOVE CHARCOAL CANISTER ASSEMBLY (a) Disconnect the connector from the canister pump module. *1 Vent Line Ho
Inspection
INSPECTION PROCEDURE 1. INSPECT CHARCOAL CANISTER ASSEMBLY (a) Visually check the charcoal canister assembly for cracks or damage. If cracks or damage is found, replace the charcoal canister assemb
Installation
INSTALLATION PROCEDURE 1. INSTALL CANISTER PUMP MODULE (a) Engage the 2 claws to install a new canister pump module to the charcoal canister assembly. NOTICE:
Do not allow foreign matter such
SEE MORE:
Radio Broadcast cannot be Received or Poor Reception
WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver a
DCM System Internal Failure (B15A804)
DESCRIPTION This DTC is stored when an internal circuit malfunction is detected by the DCM (telematics transceiver) self check. DTC No. Detection Item DTC Detection Condition Trouble Area B15A804 DCM System Internal Failure DCM (telematics transceiver) internal malfunction DCM (te
© 2016-2026 Copyright www.lexunx.com
