Lexus NX: 2ar-fxe (emission Control)

Lexus NX Service Manual / Engine & Hybrid System / 2ar-fxe (emission Control)

READ NEXT:

 Canister

 Components

COMPONENTS ILLUSTRATION *1 CANISTER PUMP MODULE *2 CHARCOAL CANISTER ASSEMBLY *3 FRONT FLOOR COVER CENTER LH *4 VENT LINE HOSE *5 AIR INLET LINE HOSE *6 PURGE LINE HOSE

 Removal

REMOVAL PROCEDURE 1. REMOVE FRONT FLOOR COVER CENTER LH Click here 2. REMOVE CHARCOAL CANISTER ASSEMBLY (a) Disconnect the connector from the canister pump module. *1 Vent Line Ho

SEE MORE:

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. INSTALL FOG LIGHT ASSEMBLY LH (a) Attach the guide. (b) Install the fog light assembly LH with the 2 screws. 2. INSTALL FRONT BUMPER ASSEM

 Low Output Signal of Front Speed Sensor RH (C1271,C1272,C1464,C1465)

DESCRIPTION Each speed sensor detects the wheel speed and sends the signals to the skid control ECU (brake booster with master cylinder assembly). These signals are used for ABS control. DTCs C1271 and C1272 are cleared when the speed sensor sends a wheel speed signal or when Test Mode ends. DTCs C1

© 2016-2026 Copyright www.lexunx.com