Lexus NX: Compressor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 BATTERY SERVICE HOLE COVER *2 HYBRID BATTERY SERVICE PLUG COVER *3 SERVICE PLUG GRIP - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUST
Removal
REMOVAL PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM Click here 2. REMOVE BATTERY SERVICE HOLE COVER Click here 3. REMOVE HYBRID BATTERY SERVICE PLUG COVER Click here 4. REMOVE
Installation
INSTALLATION PROCEDURE 1. INSPECT COMPRESSOR OIL (a) When replacing the compressor assembly with motor with a new one, gradually discharge the inert gas from the service valve, and drain the follow
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL REAR DOOR REAR WINDOW FRAME MOULDING LH (a) Install a new rear door rear window frame moulding LH. (b) Install a nose piece to an air
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Check main body ECU (multiplex network body ECU) (1) Connect the Techstream to the DLC3. (2) Turn the power switch on (IG). (3) Turn the Techstream on. (4) Enter the following menus: Body Electrical / Main Body / Trouble Codes. (5) Check for DTCs. Body Electrical >
© 2016-2026 Copyright www.lexunx.com
