Lexus NX: Control Module Communication Bus "A" Off (U0073,U0155)
DESCRIPTION
These DTCs are stored when the clearance warning ECU assembly cannot receive and recognize several signals via the CAN communication line.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0073 | Control Module Communication Bus "A" Off | Control module communication bus off | CAN communication system |
| U0155 | Lost Communication with Instrument Panel Cluster (IPC) Control Module | Lost communication with the combination meter assembly | CAN communication system |
HINT:
When 2 or more DTCs starting with "U" are output simultaneously, inspect the connectors and wire harnesses of each ECU.
PROCEDURE
| 1. | CHECK DTC OUTPUT |
(a) Clear the DTCs
Click here .gif)
(b) Check for CAN communication system DTCs
Click here
| Result | Proceed to |
|---|---|
| No CAN communication system DTCs are output | A |
| CAN communication system DTCs are output | B |
| A | .gif) | USE SIMULATION METHOD TO CHECK |
| B | | GO TO CAN COMMUNICATION SYSTEM |
READ NEXT:
CAN Communication Failure (Message Registry) (U1000)
DESCRIPTION If DTC U1000 is stored frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again even if the DTC is not output when rechecking for DTCs. DTC
No. 1 Clearance Warning Buzzer Circuit
DESCRIPTION This circuit consists of the No. 1 clearance warning buzzer and clearance warning ECU assembly. An ECU-excited type buzzer is used. The ECU operates the buzzers using a sound pattern that
Clearance Warning ECU Power Source Circuit
DESCRIPTION This circuit provides power to operate the clearance warning ECU assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before perf
SEE MORE:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspect
Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis i
