Lexus NX: Cruise Control Main Switch
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 CRUISE CONTROL MAIN SWITCH - - N*m (kgf*cm, ft.*lbf): Specified torque - -
Removal
REMOVAL PROCEDURE 1. REMOVE HORN BUTTON ASSEMBLY Click here 2. REMOVE CRUISE CONTROL MAIN SWITCH (a) Remove the 2 screws. *a Guide (b) Detach the guide. (c) Disconnect t
Inspection
INSPECTION PROCEDURE 1. INSPECT CRUISE CONTROL MAIN SWITCH (a) w/o Dynamic Radar Cruise Control System: (1) Measure the resistance according to the value(s) in the table below. *a Component with
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedures listed below are for the LH side.
PROCEDURE 1. REMOVE FRONT DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY LH HINT: When removing the front door lower outside moulding sub-assembly LH, heat the fro
Seat belts
Make sure that all occupants are
wearing their seat belts before driving
the vehicle.
WARNING
Observe the following precautions to
reduce the risk of injury in the event of
sudden braking, sudden swerving or an
accident.
Failure to do so may cause death or serious
injury.
■Wearing a se
© 2016-2026 Copyright www.lexunx.com
