Lexus NX: Egr Valve
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 AIR CLEANER CAP AND HOSE *2 EGR VALVE ASSEMBLY *3 NO. 1 ENGINE COVER SUB-ASSEMBLY *4 GASKET *5 NO. 1 EGR PIPE *6 NO. 1 WATER BY-PASS HOSE *
Removal
REMOVAL PROCEDURE 1. DRAIN ENGINE COOLANT Click here 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Click here 3. REMOVE AIR CLEANER CAP AND HOSE Click here 4. REMOVE EGR VALVE ASSEMBLY (a) Discon
Inspection
INSPECTION PROCEDURE 1. INSPECT EGR VALVE ASSEMBLY (a) Measure the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY (BRAKE HOLD SWITCH) (a) Install the integration control and panel assembly (brake hold switch) to the upper rear console panel sub-assembly with the 2 screws. HINT: The locations labeled A in the illustration are tightened t
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click here PROCEDURE 1. INSTALL OUTER BELT ANCHOR BRACKET SUB-ASSEMBLY LH (
© 2016-2026 Copyright www.lexunx.com
