Lexus NX: Front Wiper Motor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY *2 FRONT WIPER ARM HEAD CAP *3 WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH *4 WINDSHIELD WIPER ARM AND BLADE ASSEM
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (a) for LH Side: (1) Check the stop (park) position. *1 Ceramic Dot *2 Louver Lip Edge *a 34 mm
Inspection
INSPECTION CAUTION / NOTICE / HINT CAUTION: Make sure that fingers or articles of clothing do not get caught in moving parts when performing this test. PROCEDURE 1. INSPECT WINDSHIELD WIPER MOTOR ASSE
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (VSC OFF SWITCH) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 4 (+) - 1 (GND) Switch not pushed 10 kΩ or higher
If your vehicle overheats
The following may indicate that
your vehicle is overheating.
The needle of the engine coolant
temperature gauge
enters the red zone, or a loss of
hybrid system power is experienced.
(For example, the vehicle
speed does not increase.)
"Engine Coolant Temp High" or
"Hybrid System Ov
© 2016-2026 Copyright www.lexunx.com
