Lexus NX: Humidity Sensor

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 AIR CONDITIONING THERMISTOR ASSEMBLY (HUMIDITY SENSOR) *2 NO. 1 FORWARD RECOGNITION COVER *3 NO. 2 FORWARD RECOGNITION COVER *4 PROTECTOR

 Removal

REMOVAL PROCEDURE 1. REMOVE NO. 2 FORWARD RECOGNITION COVER Click here 2. REMOVE NO. 1 FORWARD RECOGNITION COVER Click here 3. REMOVE PROTECTOR (a) Detach the 2 claws and remove the protector.

 Inspection

INSPECTION PROCEDURE 1. INSPECT AIR CONDITIONING THERMISTOR ASSEMBLY (HUMIDITY SENSOR) (a) for Glass temperature sensor: (1) Measure the resistance according to the value(s) in the table below. *a

SEE MORE:

 Operation Check

OPERATION CHECK INITIAL CHECK (a) Power switch on (IG) (intuitive parking assist system off). (b) Intuitive parking assist system on and check an indication state of the vehicle mark. OK: The initial check is performed for approximately 5 seconds after the system turns on, and then the system switc

 Reassembly

REASSEMBLY PROCEDURE 1. INSTALL COOLER DRYER (a) Using pliers, install a new cooler dryer to the modulator. *1 Modulator (b) Apply sufficient compressor oil to the O-ring. Compressor Oil: ND-OIL 11 or equivalent (c) Using a 14 mm hexagon socket wrench, i

© 2016-2026 Copyright www.lexunx.com