Lexus NX: Inspection
Lexus NX Service Manual / Engine & Hybrid System / 2ar-fxe (engine Control) / Throttle Body / Inspection
INSPECTION
PROCEDURE
1. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY
| *a | Component without harness connected (Throttle with Motor Body Assembly) |
(a) Check that the throttle valve opens and closes smoothly.
(b) Check that the there is no sludge accumulating around the throttle with motor body assembly.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (M-) - 2 (M+) | 20°C (68°F) | 0.3 to 100 Ω |
If the result is not as specified, replace the throttle with motor body assembly.
READ NEXT:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repairs" after replacing the throttle with motor body assembly. Click here PROCEDURE 1. INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY
SEE MORE:
ABS Warning Light Remains ON
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) is connected to the combination meter assembly via CAN communication. If any of the following is detected, the ABS warning light remains on:
The skid control ECU (brake booster with master cylinder assembly) connector
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL REAR BUMPER PAD HINT:
When installing the rear bumper pad, heat the rear bumper cover and rear bumper pad using a heat light.
Use the same procedure described for the other side.
Standard: Item Temperature Rear Bumper Cover 20 to 30°C (68 to 86°F
© 2016-2026 Copyright www.lexunx.com
