Lexus NX: Throttle Body
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 AIR CLEANER CAP AND HOSE *2 NO. 1 ENGINE COVER SUB-ASSEMBLY *3 FUEL VAPOR FEED HOSE *4 NO. 2 FUEL VAPOR FEED HOSE ILLUSTRATION *1 THROTTLE WITH
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY (a) Put the engine in inspection mode (maintenance mode). Click here (b) Start the engine and check that the MIL is not i
Inspection
INSPECTION PROCEDURE 1. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY *a Component without harness connected (Throttle with Motor Body Assembly) (a) Check that the throttle valve opens and closes
SEE MORE:
Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices
Installation
INSTALLATION PROCEDURE 1. INSTALL PARKING BRAKE ACTUATOR ASSEMBLY LH (a) Apply a light coat of lithium soap base glycol grease to the new O-ring. (b) Install the O-ring to the rear disc brake cylinder assembly LH. (c) Using a 5 mm hexagon socket wrench, install the parking brake actuator assembly LH
© 2016-2025 Copyright www.lexunx.com
