Lexus NX: Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SHOCK ABSORBER ASSEMBLY LH
(a) Compress and extend the shock absorber rod 4 or more times and check the operating sound and resistance.
Standard:
The operating sound and resistance are normal.
If there is any abnormality, replace the front shock absorber with a new one.
READ NEXT:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL SST (a) Align the cutout on end o
Disposal
DISPOSAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH
SEE MORE:
Internal Control Module Throttle Position Performance (P060E)
MONITOR DESCRIPTION The ECM monitors the signals received from the No. 1 throttle position sensor and stop light switch assembly. As the ECM monitors the STP signal of the stop light switch assembly and the No. 1 throttle position sensor, if these signals do not correlate, this DTC is stored. DTC
Terminals Of Ecu
TERMINALS OF ECU CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *1 Main Body ECU (Multiplex Network Body ECU) - - (a) Measure the voltage and check for pulses according to the value(s) in the table below. Terminal No. (Symbol) Wiring C
© 2016-2025 Copyright www.lexunx.com
