Lexus NX manuals

Lexus NX: Installation

Lexus NX Service Manual / Vehicle Interior / Seat / Seat Memory Switch / Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT SEAT SLIDE SWITCH BEZEL

(a) Attach the 6 claws to install the front seat slide switch bezel.

2. INSTALL SEAT MEMORY SWITCH

(a) Attach the 4 claws to install the seat memory switch.

3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Click here

4. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

Click here

5. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Click here

6. INSTALL FRONT DOOR TRIM COVER LH

Click here

7. INSPECT FRONT POWER SEAT CONTROL SYSTEM

Click here

READ NEXT:

 Seat Belt

 Front Seat Inner Belt Assembly

 Components

COMPONENTS ILLUSTRATION *1 FRONT SEAT INNER BELT ASSEMBLY LH *2 FRONT SEAT INNER BELT ASSEMBLY RH *3 FRONT SEAT BELT ANCHOR PLATE - - N*m (kgf*cm, ft.*lbf): Specified torque

SEE MORE:

 Freeze Frame Data

FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever an automatic headlight beam level control system DTC is stored, the headlight ECU subassembly LH stores the current vehicle state as freeze frame data. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG).

 On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RAIN SENSOR (a) Remove the rain sensor cover. Click here (b) Disconnect the rain sensor connector. *a Front view of wire harness connector (to Rain Sensor) (c) Measure the voltage according to the value(s) in the table below. St

© 2016-2026 Copyright www.lexunx.com