Lexus NX: Precaution
Lexus NX Service Manual / Engine & Hybrid System / 2ar-fxe (engine Mechanical) / Cylinder Head / Precaution
PRECAUTION
HINT:
- Any digits beyond the 0.01 mm (1/1000 in.) place for standard, minimum and maximum values should be used as a reference only.
- When both standard and maximum or minimum values are listed for an inspection, use the standard value as a reference only and base any judgments on the maximum and minimum values.
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 EXHAUST VALVE *2 EXHAUST VALVE GUIDE BUSH *3 INTAKE VALVE *4 INTAKE VALVE GUIDE BUSH *5 NO. 1 STRAIGHT SCREW PLUG *6 NO. 2 STRAIGHT SCREW PLUG
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE INTAKE VALVE (a) Using SST and wooden blocks, compress the inner compression spring and remove the valve spring retainer locks. SST: 09202-70020 SST: 09202-00021
Inspection
INSPECTION PROCEDURE 1. INSPECT CYLINDER HEAD SUB-ASSEMBLY (a) Using a precision straightedge and feeler gauge, measure the warpage of the contact surfaces where the cylinder head contacts the cylinde
SEE MORE:
Operation Check
OPERATION CHECK INPUT SIGNAL CHECK (a) Connect the Techstream to the DLC3. (b) Check the cruise control main switch using the Data List function of the Techstream (ON-OFF, -SET, +RES and CANCEL). *a +RES *b -SET *c ON-OFF *d CANCEL Click here INSPECT CRUISE CONTROL MAIN
Rear Left Seat Heat Sensor Circuit (B14C3)
DESCRIPTION Power supply to the temperature sensor built into the rear seat cushion heater stops if one of the following occurs: 1) an open or short occurs in the temperature sensor circuit; or 2) the temperature sensor is damaged and its output value does not change. DTC No. Detection Item D
© 2016-2026 Copyright www.lexunx.com
