Lexus NX: Precaution
PRECAUTION
NOTICE:
When disassembling the headlight assembly, use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).
STATIC ELECTRICITY COUNTERMEASURES SST
SST:Desktop antistatic mat set (09890-47010)
-
Wristband
SST:
09891-04020
-
Wristband connection wire (No. 1 grounding wire)
SST:
09891-04030
-
Antistatic mat
SST:
09891-04010
-
Ground connection wire (No. 2 grounding wire)
SST:
09891-04040
.png)
PRECAUTIONS DURING REPLACEMENT
(a) Precautions during procedures:
(1) Before performing any procedures, touch an unpainted metal part or ground bolt of the vehicle to eliminate any static electricity.
(2) To prevent damage to electrical equipment, disconnect the battery power supply before installing and removing electrical equipment.
(3) Never touch the electronic parts of a printed wire board or the pins of an integrated circuit.
(4) When performing procedures, do not allow clothing to come near or contact parts.
(b) Wear the SST (wristband) firmly on your wrist.
SST:
09891-04020
(c) Connect the SST (No. 2 grounding wire) and SST (antistatic mat) to an appropriate grounding point in the workspace and on the work table.
SST:
09891-04040
09891-04010
HINT:
When working inside the vehicle:
Connect SST (No. 2 grounding wire) to the unpainted metal part of a grounded bolt, etc.
.png)
(d) Connect SST (No. 1 grounding wire), SST (wristband) and SST (antistatic mat).
SST:
09891-04030
(e) Always place the headlight assembly and its components on SST (antistatic mat).
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 HEADLIGHT ASSEMBLY LH - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 HEADLIGHT ECU SUB-ASSEMBLY LH *2 HEADLIGHT GASKET
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY (a) except Spo
Disassembly
DISASSEMBLY PROCEDURE 1. PRECAUTION NOTICE:
Be sure to read Precaution thoroughly before servicing.
Click here
Do not reuse parts which have reduced fastening ability due to thread damage.
Wh
SEE MORE:
Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION (a) Lighting system data and the Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions, and then perform repairs. CHECK DLC3 (a) Check the
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be dis
