Lexus NX: Repair
REPAIR
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- If the installation area of the headlight assembly is damaged, use the supply retainer for low-cost repair.
- Make sure that the headlight assembly is not damaged.
PROCEDURE
1. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER RH
| (a) Cut off the blue-colored part in the illustration and sand smooth with sandpaper. NOTICE: After cutting off the part, place the upper headlight protector retainer RH against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer. |
|
.png)
| (b) Install the upper headlight protector retainer RH with the 2 screws. |
|
.png)
2. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER LH
| (a) Cut off the blue-colored part in the illustration and sand smooth with sandpaper. NOTICE: After cutting off the part, place the upper headlight protector retainer LH against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer. |
|
.png)
| (b) Install the upper headlight protector retainer LH with the 2 screws. |
|
.png)
3. INSTALL LOWER HEADLIGHT PROTECTOR RETAINER LH
| (a) Cut off the blue-colored part in the illustration and sand smooth with sandpaper. NOTICE: After cutting off the part, place the lower headlight protector retainer LH against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer. |
|
.png)
| (b) Install the lower headlight protector retainer LH with the 2 screws. |
|
.png)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 AUXILIARY BATTERY NEGATIVE TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTION CAUTION: Be sure to read Precau
SEE MORE:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use this procedure to troubleshoot the climate control seat system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT 2. CUSTOMER PROBLEM ANALYSIS HINT:
In troubleshooting, confirm that the problem symptom
Transmitter Battery
ReplacementREPLACEMENT PROCEDURE 1. REMOVE TRANSMITTER BATTERY (a) Push the release hook knob and extract the mechanical key. (b) Using a screwdriver with its tip wrapped in protective tape, remove the transmitter housing cover as shown in the illustration. HINT: Tape the screwdri
