Lexus NX: Automatic High Beam System (B124B)
DESCRIPTION
The main body ECU (multiplex network body ECU) determines the status of the automatic high beam system based on the automatic high beam system signal from the forward recognition camera.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B124B | Automatic High Beam System | Malfunction in automatic high beam system |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this symptom
Click here .gif)
HINT:
If the forward recognition camera stores a DTC for a malfunction of any of the following, this DTC will be stored simultaneously.- Speed sensor malfunction
- Yaw rate sensor malfunction
- Steering sensor malfunction
- CAN communication system
PROCEDURE
| 1. | CHECK FOR DTC (HEALTH CHECK) |
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: System Select / Health Check.
(e) Check for DTCs.
| Result | Proceed to |
|---|---|
| Only DTC B124B is output | A |
| DTC B124B is output at the same time | B |
| B | .gif) | GO TO OTHER DTC CHART |
|
.gif)
| 2. | CHECK FORWARD RECOGNITION CAMERA |
(a) Check if a dynamic radar cruise control system, lane tracing assist system, road sign assist system and pre-collision system warning message are displayed on the combination meter assembly.
Click here
OK:
No dynamic radar cruise control system, lane tracing assist system, road sign assist system and pre-collision system warning messages are displayed.
| OK | | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
| NG | | GO TO FRONT CAMERA SYSTEM |
READ NEXT:
Automatic High Beam Camera (B124C)
DESCRIPTION The main body ECU (multiplex network body ECU) detects a high beam headlight illumination request signal of the automatic high beam system from the forward recognition camera. DTC No.
Lost Communication with Front Camera Module (U023A)
DESCRIPTION These DTCs are stored when the CAN communication system is malfunctioning. DTC No. Detection Item DTC Detection Condition Trouble Area U023A Lost Communication with Front Ca
Automatic High Beam System does not Operate or Operation Indicator does not Illuminate
DESCRIPTION The main body ECU (multiplex network body ECU) controls the automatic high beam system based on signals received from the forward recognition camera. WIRING DIAGRAM CAUTION / NOTICE / HIN
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT w/ Blind Spot Monitor System: HINT: If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not be operating correctly, so visually inspect the blind spot monito
Removal
REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE BACK DOOR SIDE GARNISH LH Click here 3. REMOVE BACK DOOR SIDE GARNISH RH HINT: Use the same procedure described for the LH side. 4. REMOVE BACK DOOR TRIM BASE (w/ Power Back Door) Click here 5. REMOVE PULL HANDLE (w/ Pow
