Lexus NX: Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Air Conditioner / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Air Conditioner > Data List| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| FR Seat Heater Temperature | Front seat RH heater temperature | -29.7°C to 59.55°C | Within range from 32 to 43°C (89 to 109°F) | Front seat heater is on |
| FL Seat Heater Temperature | Front seat LH heater temperature | -29.7°C to 59.55°C | Within range from 32 to 43°C (89 to 109°F) | Front seat heater is on |
| Number of Trouble Codes | Number of trouble codes | 0 to 255 | Number of DTCs will be displayed | - |
READ NEXT:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Seat Heater System DTC No. Detection Item Link B14C0 Front Right Seat Heat Sensor Circuit B14C1 Front Left Seat Heat Sensor Circuit B14C2
Front Right Seat Heat Sensor Circuit (B14C0)
DESCRIPTION Output to the front seat cushion heater temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and i
Front Left Seat Heat Sensor Circuit (B14C1)
DESCRIPTION Output to the front seat cushion heater temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and i
SEE MORE:
Power Back Door cannot be Operated Using Kick Sensor
DESCRIPTION The kick door control sensor receives vehicle speed, IG and ACC signals from the main body ECU (multiplex network body ECU) via LIN communication and uses the information to stop sensor oscillation. When the kick door control sensor detects a kick operation, it sends a operation signal t
Removal
REMOVAL CAUTION / NOTICE / HINT w/ Blind Spot Monitor System: HINT: If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not be operating correctly, so visually inspect the blind spot monito
