Lexus NX: Installation
INSTALLATION
PROCEDURE
1. PRECAUTION
CAUTION:
Be sure to read precaution thoroughly before servicing.
Click here .gif)
2. INSTALL REAR TIRE PRESSURE MONITOR INITIATOR
(a) Install the rear tire pressure monitor initiator with the 2 nuts.
Torque:
8.3 N·m {85 kgf·cm, 73 in·lbf}
(b) Connect the grommet.
(c) Connect the connector of the rear tire pressure monitor initiator and install the service hole cover.
3. INSTALL REAR WHEEL HOUSE LINER LH
(a) Install the rear wheel house liner LH with the 3 clips (A) and 9 clips (B).
4. INSTALL REAR WHEEL HOUSE FRONT PLATE LH
(a) Install the rear wheel house front plate LH with the screw and 2 clips.
5. INSTALL REAR BUMPER SIDE SEAL LH
(a) Install the rear bumper side seal LH with the 2 clips.
6. INSTALL QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH
Click here
7. INSTALL REAR WHEEL (for LH Side)
Click here
8. INSPECT TIRE PRESSURE WARNING SYSTEM
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the power switch off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal. Click here 2. REMOVE NO. 3 D
SEE MORE:
Heated steering wheel/seat heaters/
seat ventilators
Heated steering wheel
Warm up the grip of the steering wheel
Seat heaters
Warm up the seat upholstery
Seat ventilators
Maintain good airflow on the seat upholstery
by blowing air from the seats
WARNING
■To prevent minor burn injuries
Care should be taken if anyone in the fo
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY NOTICE: Do not reuse dropped or damaged parts. (a) Attach the clamp and install No. 1 indoor electrical key antenna assembly. (b) Connect each connector. 2. INSTALL SHIFT LEVER ASSEMBLY Click here 3. INSTALL UPPER REAR
