Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH
(a) Attach the 6 claws to install the rear door belt moulding assembly LH.
2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
Click here .gif)
3. INSTALL REAR DOOR REAR GUIDE SEAL LH
Click here
4. INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH
Click here
5. INSTALL REAR DOOR FRAME GARNISH LH
Click here
6. INSTALL REAR DOOR WEATHERSTRIP LH
Click here
7. CONNECT REAR DOOR CHECK ASSEMBLY LH
Click here
8. INSTALL REAR DOOR GLASS RUN LH
Click here
9. INSTALL REAR DOOR SERVICE HOLE COVER LH
Click here
10. INSTALL REAR DOOR ARMREST SET BRACKET LH
Click here
11. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH
Click here
12. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
Click here
13. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
Click here
14. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH
Click here
15. INSTALL REAR DOOR TRIM COVER LH
Click here
16. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
17. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
18. INSTALL DECK FLOOR BOX LH
Click here
19. INSTALL REAR DECK FLOOR BOX
Click here
20. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
21. CHECK POWER WINDOW CONTROL SYSTEM
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 OUTSIDE MOULDING RETAINER *2 REAR DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY LH *3 REAR DOOR NO. 2 WEATHERSTRIP LH *4 REAR DOOR REAR UPPER OUTSIDE MOULDING
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedures listed below are for the LH side.
PROCEDURE 1. REMOVE REAR DOOR LOWER OUTSIDE MOULDING SUB-
SEE MORE:
Open in Rear Floor Electrical Key Oscillator Circuit (B27A6)
DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the No. 2 indoor electrical key antenna assembly (rear floor). For the No. 2 indoor electrical key antenna assembly (rear floor) to detect when the electrical key transmitter sub-assembl
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: After the power switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the power switch off, be sure to wait for the time specified in th
